Support Handle; Edger Blade Installation - Echo BRD-280 Operator's Manual

Bed redefiner

Hide thumbs Also See for BRD-280:

Table of Contents

ASSEMBLY

6. Gather ignition wires and position behind air filter case.

7. Install air filter and cover.

Support Handle

1. Position support handle in comfortable operating position

and tighten screws.

Note: Label shows minimum spacing for support handle

location.

1. Remove bed redefining blade as shown in "Blade

Replacement" Section. Discard used split pin.

2. Do not remove inner blade adapter (A) or locking tool (B).

3. Install and center edger blade (C) on inner adapter .

4. Install outer adapter (D) and nut (E).

5. Tighten nut (E) firmly, counterclockwise.

6. Remove locking tool (B).

7. Install new split pin (F) to secure nut (E).

BRD-280

X7502311208

Table of Contents