Drive Shaft Lubrication; Blade Replacement/Lubrication - Echo BRD-280 Operator's Manual

Bed redefiner

Hide thumbs Also See for BRD-280:

Table of Contents

BRD-280

Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations.

Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer.

1. Check idle speed and reset if necessary. If a tachometer is

available, idle speed screw (A) should be set to the

specifications found on "Specifications" page of this manual.

Turn idle screw (A) clockwise to increase idle speed; counter

clockwise to decrease idle speed.

When carburetor adjustment is completed, the cutting

attachment should not move at idle, otherwise serious

personal injury may result.

Drive Shaft Lubrication

Level 1.

Parts

POWER BLENDX

Required:

Grease.

1. Loosen two (2) screws (A) and remove center locating

screw (B). Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean

and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the flexible cable back in the drive housing. DO NOT

get dirt on the flex cable.

4. Install the gear housing and shield assembly.

5. Tighten screws securely.

Level 1.

Parts Required:

Blade, new split pin

Note: Grease gear case every 15 - 25 hours of use. Replace blade when carbide tips have worn away.

X7502311208

8 oz. or Lithium Base

MAINTENANCE

Table of Contents