Assembly; Drive Shaft/Power Head; Throttle Linkage And Ignition Leads - Echo PE-225 Operator's Manual

Power edger

Hide thumbs Also See for PE-225:

Table of Contents

ASSEMBLY

Parts Required:

Power Head, Drive Shaft Assembly

1. Stand engine on a level surface.

2. Remove vinyl cap from drive shaft.

3. Loosen the two bolts (A) at drive shaft end of engine.

4. Carefully fit drive shaft assembly to engine, making sure that

inner drive shaft engages into clutch mount.

Note: Rotate the drive shaft housing until edger housing is in

line with the engine.

5. Tighten bolts (A).

1. Close choke and remove air filter cover.

2. Place throttle linkage (A) into adjustment fixture (B) and

install wire end into large carburetor throttle swivel hole (C).

Check throttle for freedom of movement and that wide open

throttle / low idle extremes are adjusted properly. The

throttle linkage must be adjusted by moving the adjustment

nut (D). Consult with your Echo Dealer for correct

adjustment procedure.

3. Tighten nut (E).

4. Connect 2 ignition stop leads (F, G) from throttle cable

tubing to 2 ignition leads (F, G) on engine.

PE-225

X7722279201

Table of Contents