Problem solving guide
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages in the display
Problem
You are asked to enter a
code.
Adjust the load
The programme is
cancelled, the
buzzer sounds.
Empty the
container
The programme is
cancelled, the
buzzer sounds.
46
Possible cause
Access via a code has
been activated.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
The condensed water
container is full or there is
a kink in the drain hose.
Remedy
Enter the code (see
Settings menu).
Use the Warm air
programme in future for
drying individual items.
– Open and shut the
door.
– Empty out the
condensed water
container or check the
drain hose.
– Switch the dryer off
and back on again.