Levelling The Appliance; Room Ventilation; Washer-Dryer Stack; Before Moving The Tumble Dryer Again (E.g. When Moving House) - Miele T 4859 Ci Operating Instructions Manual

Levelling the appliance

Turn the 4 screw feet to adjust the
dryer to the correct height and level.
Longer screw feet are available as
an optional accessory. Unscrew and
remove the feet supplied with the
appliance before fitting the longer
screw feet.
The cover plate on the dryer must
be aligned horizontally underneath
the worktop.
The ventilation gaps in the plinth
must not be covered over. This
would hinder a sufficient flow of air
to the dryer.
Installation and connection

Room ventilation

Air taken in for use in the drying
process will be warm when it is
expelled from underneath the dryer.
This expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.

Washer-dryer stack

The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit
(available to order) to match your dryer
is required.
The stacking kit must be fitted by
a suitably qualified fitter.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the dryer is tipped up when it is
being moved. It is therefore a good
idea to run the Cool air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
55