To Install The Main Unit And Speakers On The Wall - Sharp SD-EX220H Operation Manual

1-bit digital audio system
Hide thumbs Also See for SD-EX220H:
Table of Contents

Advertisement

To install the main unit and speakers on the wall

SD-EX220H
ENGLISH
CAUTION:
! Be very careful to prevent the main unit [3.7 kg (8.2 lbs.)] from falling when mount-
ing on the wall.
! Before mounting, check the wall strength. (Do not put to the veneer plaster or
whitewashed wall. The main unit or speakers may fall.) If it is not clear, consult
with a qualified service technician.
! Mounting screws are not supplied. Use appropriate ones.
! Check all mounting screws for looseness and that they are engaged in the main
unit and speakers.
! Mount the main unit and speakers on the wall with 2 screws for each.
! Select a good location. If not, accidents may occur or the unit may get damaged.
! Avoid placing on a bed, sofa, water tank, sink and hallway wall.
! To avoid accidents, fix the speaker wires to the wall. You may trip over them.
! SHARP is not responsible for accidents resulting from improper installation.
" Driving screws
Sharp designed the main unit and speakers so you may hang them on the wall.
Use proper screws (not supplied). See below for size and type.
5 mm (3/16")
Min. 22 mm (7/8")
1
Make a hole in the wall using a drill.
8-9 mm (3/8")
2
Drive a wall mount plug into the hole using a hammer, until it is
flush with the wall surface.
E-9
3.2 mm (1/8")
9 mm (3/8")
32 mm (1-1/4")
3
Drive two screws into the wall for main unit and each speaker, as
shown in the illustration.
! Make sure that both the screw and the wall can support a load of 20 kg (45
lbs.).
! Drive the screws, so the screw head extends about 5.5 mm (7/32") out from
the wall.
Wall surface
Wall mounting screw
" Installing the main unit
1
Fix the pattern paper and drive two screws into the wall with a dis-
tance of 160 mm (6-5/16") in between.
)
5 / 1 6 "
m ( 6 -
1 6 0 m
2
Tighten the screws and remove the paper. Hook the main unit on
the screw heads and make sure it is secure.
Wall surface
Put the left speaker wire in the groove on the back of the main unit.
03/6/9
SD-EX220H(H)_E.fm
5.5 mm (7/32")
Wall surface
Pattern paper
for main unit
Speaker wire
TINSZ0953AWZZ

Advertisement

Table of Contents
loading

Table of Contents