Information With Error Messages - Sharp R-23AT Operation Manual

A40085 SEEG R25AT O/M
COUNTER RESET
Each number of times can be cleared.
Example : Suppose you want to clear the times of memory 1.
Step
1 Choose checking mode.
2 Choose the memory 1.
3 Clear times of using the memory 1.
4 Cancel checking mode.
NOTE:
1. To clear times of manual cooking, touch MANUAL/REPEAT key (
To clear times of Defrost cooking, touch EXPRESS DEFROST key (
key.
2. To clear total using times, skip step 2.

INFORMATION WITH ERROR MESSAGES

If ERROR messages are displayed, follow the below instructions.
ERROR MESSAGES
EE1, EE2, EE3,
EE6, E10, EE16
EE8,EE0 (For R-23AT)
EE19 (For R-25AT )
EE7
EE9
EE17
INFORMATION WITH FILTER INDICATOR
Clean the air intake filter when the FILTER indicator lights up (See page 14.). The FILTER indicator will light up
when the oven has been operated for about 200 hours in total.
To cancel FILTER indicator touch the START key (
automatically again when the FILTER indicator is canceled.
SEEG R23AT Eng,P04-12
Action
Please contact your dealer or an authorized Sharp service agent because the oven
must be out of order.
Exhaust air temperature is too high. Checking that nothing is blocking the ventilation
openings or that room temperature is very hot or that oven cavity is empty during
operation. Correct, touch STOP/CLEAR key (
minutes.
The time you set exceeds a maximum time. Touch STOP/CLEAR key (
enter appropriate time.
Magnetron temperature is too high, touch STOP/CLEAR key (
after a few minutes.
12
Press Key
X 2
1
) at step 2 instead of NUMBER key.
) at step 2 instead of NUMBER
) and try again after a few
). The oven will start to count the operation time
12
03.7.16, 2:55 PM
Display
CHECK
CHECK will flash on and off.
(Total count)
CHECK
NUMBER
(Times memory 1 used)
CHECK
NUMBER
) and
) and try again