Transporting The Unit - Sharp MD-R3 Operation Manual

(Continued)
Moisture condensation
In the following cases, condensation may form inside
the unit.
Shortly after turning on a heater.
When the unit is placed in a room where there is exces-
sive steam or moisture.
When the unit is moved from a cool place to a warm
place.
When the unit has condensation inside, the disc signals
cannot be read, and the product may not function prop-
erly.
If this happens, remove the disc, and open the disc tray.
The condensation should evaporate in approximately 1
hour. The unit will then function properly.
If a power failure occurs during recording
If the AC power plug is disconnected from the AC outlet
or a power failure occurs during recording (before the
TOC information has been recorded on the disc), the
audio portion being recorded at that time will be erased.
When a recording is being added to a MiniDisc which
already has a recording on it, and the TOC is not up-
dated before the power failure, the added recording will
be erased.
If a power failure occurs or the AC power cord is dis-
connected for about 10 minutes, the TOC will be written
on the disc when power is restored.

TRANSPORTING THE UNIT

1,4,5 2
If a problem occurs
If this product is subjected to strong external interfer-
ence (mechanical shock, excessive static electricity, ab-
normal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction or the display
may not function correctly. If such a problem occurs,
do the following:
Unplug the AC power cord from the AC outlet.
Wait about 20 - 30 seconds and then plug the AC power
cord back into the AC outlet.
Press the RESET button on the back of the unit.
When the RESET button is pressed, all of the settings
in memory will be erased.
If strange sounds, smells or smoke come out of the unit
or if a foreign object falls into the unit, turn off the power
and unplug the AC power cord from the AC outlet, im-
mediately. Contact your nearest authorized Sharp ser-
vicer.
When transporting the unit, proceed as follows:
1
Press the POWER button to turn the power on.
2
Remove all discs CDs/MD from the unit.
2
3
Press the RESET button on the rear of the unit.
When the RESET button is pressed, all of the settings in mem-
ory will be erased.
4
Make sure "TIME ADJUST" appears in the display, then press
the POWER button to turn the power on again.
5
Press the POWER button to turn the power off.
6
Make sure the message on the display has changed from
"GOOD BYE!" to "TIME ADJUST", and then unplug the AC
power cord from the AC outlet.
43
MD-R3
RESET
Pen, pencil, etc.