Headphone Connection - Sharp HT-DV40U Operation Manual

HT-DV40U
Timer and sleep operation (Remote
HT-DV50U
Control only) (continued)
ENGLISH
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
1 Whilst "SLEEP" is indicated, press the CLOCK/TIMER button.
2 Within 10 seconds, press the
OFF", and press the MEMORY/DIMMER button.
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD the next morning.
1 Set the sleep time (see left, steps 55 - 54).
2 Whilst the sleep timer is set, set the timer playback (steps 2 -
10, pages 54 - 55).
Sleep timer setting
1 minute - 3 hours
Sleep operation will
automatically stop
E-57
or button to select "SLEEP
Timer playback setting
Desired time
Timer playback start time

Headphone connection

Before plugging in or unplugging the headphone, reduce the
volume.
Be sure your headphone have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in
End time automatically. Adjust the volume using the VOLUME control.
the headphone disconnects the speakers