Headphone Connection - Sharp HT-DV40H Operation Manual

HT-DV40H
Timer and sleep operation (Remote
HT-DV50H
Control only) (continued)
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
1 Whilst "SLEEP" is indicated, press the CLOCK/TIMER button.
2 Within 10 seconds, press the
OFF", and press the MEMORY/DIMMER button.
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD the next morning.
1 Set the sleep time (see left, steps 1 - 5).
2 Whilst the sleep timer is set, set the timer playback (steps 2 -
10, pages 59 - 60).
Sleep timer setting
1 minute - 3 hours
Sleep operation will
automatically stop
62
or button to select "SLEEP
Timer playback setting
Desired time
Timer playback start time

Headphone connection

Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and
headphone can cause hearing loss.
Before plugging in or unplugging the headphone, reduce the
volume.
Be sure your headphone have a 3.5 mm (1/8") diameter plug and
End time
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in
automatically. Adjust the volume using the VOLUME control.
the headphone disconnects the speakers