Setting A Component Code By The Search Function - Sony RM-VL610T Operating Instructions Manual

Setting a Component Code by
the Search Function
You can find a code number available for a
component that does not have one in the supplied
"Component code numbers."
Before starting the Search function
Set each component to the following status so that
the Search function works effectively.
TV, AMP: Power-on
CD player, MD player*, cassette deck: Power-on
with a playback source (disc, cassette tape, etc.)
Other components: Power-off
* If any of these components are assigned to any of
the Component Select buttons (page 24), you can
set a component code using the Search function.
1
Press and while holding SET, press MENU.
The SET indicator lights up.
10
2
Press the Component Select button for the
desired component.
The SET indicator and the selected Component
Select button light up.
3
Press PROG + or PROG –, and then 1 in
turn until the component reacts as
described in the following.
TV, AMP: Powers off
VCR, CBL, SAT, DVD: Powers on
CD player, MD player, cassette deck: Plays back
Press PROG + to go to the next code number.
Press PROG – to go back to the previous code
number.
The Component Select button flashes three times
after the numbers have turned one cycle.
One cycle means, for example, the four-digit
code numbers beginning from "8" are cycled
through.
4
Press ENT.
The SET indicator and the Component button
turn off.
If the Component Select button flashes five
times before turning off, it means that the setup
is incomplete. Start over from Step 1.