Advanced Features; Controlling The Volume Of Visual Components Connected To An Audio System - Sony RM-VL610T Operating Instructions Manual

Advanced Features

Controlling the Volume of Visual
Components Connected to an
Audio System
The Commander is factory preset based on the
assumption that you hear the sound of your visual
components from your TV speakers, and that you
hear sound of your audio components from the
loudspeakers connected to your amplifier.
For example, to control the volume while using a
VCR, you do not need to press the TV button to
control the TV volume.
The following table shows the factory setting of
which volume would be controlled for each
component.
Component Select button
TV
VCR
CBL
DVD
SAT
AMP
CD
TAPE
However, if your visual components are connected
to an audio system, you may want to hear TV or
VCR sound from the loudspeakers via your
amplifier, not from your TV speakers. In this case,
you need to change the factory preset so that you
can control the volume of your visual components
without first having to switch to the amplifier.
Controls the volume of
TV
TV
TV
TV
TV
amplifier
amplifier
amplifier
To change the Factory Preset of the Volume
Control
1
Press and while holding SET, press MENU.
The SET indicator lights up.
2
While holding % pressed, press 2 + or 2
–.
To set all volume controls to AMP
Press 2 + while holding % pressed.
All Component Select buttons light up when
you press these buttons, and then turn off when
you release them.
Press and while holding 2 +, press %.
Volume control setting complete.
19
Continued