Table of Contents
Advertisement
Loading Paper
4-6
DP N17 User Guide
Slide end guide B (2) out to align it with end guide A (1).
3
Load paper so that it is under both the metal stop tab and the plastic
4
fill tabs and adjust the side guide to the edge of the stack as needed.
Refer to Figure 4.1 on page 4-7 for correct paper orientation.
Ensure that all sheets of paper are aligned in the paper tray.
It should not be necessary to fan the paper before loading it,
however if paper feeding problems occur with some paper,
you may want to remove the paper and lightly fan it.
The type of paper loaded (plain, prepunched, letterhead,
transparency, etc.) must be set using the Tray 1 Type item in
the Control Panel's Tray Menu (refer to Chapter 3 of the
System Administrator Guide).
Advertisement
Table of Contents
