Sharp CD-G10000DVD Operation Manual page 65

Recording to a cassette tape (continued)
Recording from several CDs continuously:
1. Perform steps 1 - 6 in "Recording from a CD (CDs)" on page 63.
2. Within 5 seconds, press the 0 button to record on side A, or the 1 button
for side B.
To perform programmed recording:
1. Programme discs and tracks. (See page 51.)
2. Press the I6 button.
3. Press the 0 button to record on side A, or the 1 button for side B.
Note:
To record on both sides, begin with side A. (If recording is started from side B,
the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording, the system
will record the interrupted track on side B from its beginning. The recording will
be made without cutting the beginning of the track on side B.
*CD-G10000DVD(EN)60-65 64
Recording from the radio
H
1
Tune in to the desired station. (See page 56.)
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one side.
4
Press the I6 button.
Recording will be paused.
5
Press the 0 button to record on side A, or the 1 button
for side B.
To record on both sides, begin with side A. (If recording is started from
side B, the tape will not switch over to side A.)
To interrupt recording:
Press the I6 button.
To resume recording, press the same recording button you pressed in step 5.
Other buttons do not allow resuming.
To stop recording:
Press the H button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop
aerial.
05.1.17, 10:51
CD-G10000DVD (S)
TINSZA160AWZZ
CD-G10000DVD
CP-G10000
ENGLISH
7
E-64