Listening To The Radio - Sharp XL-E15H Operation Manual

Listening to the radio

ON/ STAND-BY ON/ STAND-BY
ON/ STAND-BY ON/ STAND-BY
FUNCTION FUNCTION
PRESET PRESET
FOLDER FOLDER
TUNING TUNING
Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER button on the remote control or FUNCTION
button repeatedly on the main unit to select tuner function.
3 Press the TUNING/FOLDER (
desired station.
Manual tuning:
Press the TUNING/FOLDER (
required to tune in the desired station.
Auto tuning:
When the TUNING/FOLDER (
more than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/FOLDER
( or ) button again.
To receive FM stereo transmission:
Press the TUNER (BAND) button to select stereo mode and "ST"
indicator will be displayed.
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the "ST" indicator. The reception changes to
monaural, and the sound becomes clearer.
FM stereo mode indicator
MICRO COMPONENT SYSTEM MICRO COMPONENT SYSTEM
XL-E15 XL-E15
REMOTE REMOTE
SENSOR SENSOR
PHONES PHONES AUDIO IN AUDIO IN
TUNER TUNER
[BAND] [BAND]
MEMORY / MEMORY /
DISP DISP
or ) button to tune into the
or ) button as many times as
or ) button is pressed for
E-12
Memorising a station
You can store 40 FM and AM stations in memory and recall them at
the push of a button (PRESET (
1 Perform steps 1 - 3 in "Tuning" on page 12.
2 Press the MEMORY/DISP button to enter the preset tuning
saving mode.
3 Within 5 seconds, press the PRESET (
the channel to be preset.
4 Press the MEMORY/DISP button.
In this example, "103.25 MHz" FM station is preset on FM
channel 9.
5 Repeat steps above to add more preset stations.
When presetting a new station, the previous preset station
is cleared.
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become
disconnected.
To recall a memorised station
Press the PRESET ( or
select the desired station.
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan).
1 Press the PRESET ( or
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or
station is located.
PRESET PRESET
or )).
or ) button to select
) button for less than 0.5 seconds to
) button for more than 0.5 seconds.
) button again when the desired