Listening To The Radio; To Scan The Preset Stations - Sharp CP-BH250 Operation Manual

Listening to the radio

TIMER
REMOTE
SENSOR
RRMCGA409AWSA
■ Tuning
Press the ON/STANDBY button to turn the power on.
1
Press the FUNCTION button repeatedly on the main
2
unit or TUNER (BAND) button repeatedly on the
remote control to select the desired frequency band
(FM or AM).
Press the TUNING (
3
desired station.
Manual tuning:
Press the TUNING (
required to tune in to the desired station.
Auto tuning:
Press and hold TUNING ( or ) button, scanning will
start automatically and the tuner will stop at the first
receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING (
button again.
) button to tune in to the
or
) button as many times as
or
To receive an FM stereo transmission:
● Press the TUNER (BAND) button on the remote
control to display the "ST" indicator.
● " " will appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER (BAND)
button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clearer.
■ Memorizing a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
Perform steps 1 - 3 in "Tuning".
1
Press the MEMORY
2
button to enter the
preset tuning saving
mode.
Within 30 seconds, press the PRESET ( or ) button
3
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
Within 30 seconds, press the MEMORY button to
4
store that station in memory. If the "MEMORY" and
preset number indicators disappear before the station
is memorized, repeat the operation from step 2.
Repeat steps 1 - 4 to set other stations, or to change
5
a preset station. When a new station is stored in the
memory, the station previously memorized for that
preset channel number will be erased.
Note:
The backup function protects the memorized stations for
a few hours should there be a power failure or the AC
power cord become disconnected.
■ To recall a memorized station
Press the PRESET (
station.

■ To scan the preset stations

The stations saved in the memory can be scanned
automatically. (Preset memory scan)
Press and hold the PRESET (
1
preset number will flash and the programmed stations
will be tuned in sequentially, for 5 seconds each.
Press the PRESET (
2
desired station is located.
■ To erase entire preset memory (In TUNER
function)
Press and hold CLEAR button until 'TUNER CLEAR'
appears.
or )
E-15
) button to select the desired
or
) button. The
or
) button again when the
or