Enhancing Your System; Timer And Sleep Operation - Sharp XL-E15H Operation Manual

Timer and sleep operation (continued)
Sleep operation
The radio, compact disc and audio in mode can all be turned off
automatically.
1 Play back the desired sound source.
2 Press the SLEEP button repeatedly to select the time.
(Maximum: 90 minutes - Minimum: 10 minutes)
3 The unit will enter the power stand-by mode automatically after
the preset time has elapsed.
To confirm the remaining sleep time:
1 Press the SLEEP button once.
The remaining sleep time is displayed for about 10 seconds.
You can change the remaining sleep time whilst it is
displayed by pressing the SLEEP button (step 2).
To cancel the sleep operation:
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
1 Press the SLEEP button repeatedly to select "SLEEP 00".
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
1 Set the sleep time (see "Sleep Operation").
2 Whilst the sleep timer is set, set the timer playback (steps 2 -
14, page 13).
Sleep timer setting Timer playback setting
90 minutes
Sleep operation will
automatically stop
End time
Desired time
Timer playback start time
E-14

Enhancing your system

The connection lead is not included. Purchase a commercially
available lead as shown below.
MICRO COMPONENT SYSTEM MICRO COMPONENT SYSTEM
ON/ STAND-BY ON/ STAND-BY
PRESET PRESET
PHONES PHONES
Listening to the playback sounds of
portable audio player, etc.
1 Use a connection lead to connect the portable audio player etc.
to the AUDIO IN socket.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button.
4 Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
If volume level is too low, increase the volume of the connected
device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and
headphones can cause hearing loss.
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
Portable audio player, etc.
Audio cable
(not supplied)
XL-E15 XL-E15
REMOTE REMOTE
SENSOR SENSOR
PHONES PHONES AUDIO IN AUDIO IN
AUDIO IN AUDIO IN