Stove Leg Installation; Pedestal (Part # 99200106); Using Outside Air With The Pedestal - Lopi Liberty Owner's Manual

30

Stove Leg Installation

Part Numbers: Brass # 99200500, Cast Black # 99200800, Sculptured Steel # 99200105

Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
These rubber-tipped bolts are for leveling the stove.
Make sure they contact the floor. Do not adjust
with weight on the legs, the rubber tips may tear.

Pedestal (Part # 99200106)

If using outside air with the pedestal, follow the directions below under "Using Outside Air with the
Pedestal" prior to installing the pedestal.
Attachment Bolts and
Washers - use a 9/16"
socket wrench to
attach the pedestal to
the stove.
OUTSIDE AIR EQUIPMENT
Insulation is
used to seal
the side edges
of the pedestal
.

Using Outside Air with the Pedestal

Before installing, check the section "Outside Air Requirements" 11 for installation concerns.
1. Determine the location of the outside air hole penetrating the floor (and hearth). The illustration
above details the size of pedestal and its location in relation to the stove. The hole may be cut
anywhere underneath the pedestal, as long as it is not within 2" of the outside perimeter of the
pedestal, is at least 16 square inches in area, and does not interfere with structural members of
the home. Place the rodent screen over the hole (above or below) and secure with staples.
2. Attach the stove to the pedestal with the included bolts. Tuck the included insulation underneath
the side edges of pedestal to seal off any air from entering underneath the pedestal.
© Travis Industries
Optional Equipment
23 5/8"
Screen is used
to prevent
rodents from
entering.
100-01274
Optional Air
Intake Port
When attached, the faceplate of
the stove is 4 3/4" in front of the
front edge of the pedestal.
Staples are
used to attach
the screen to
the floor.
9/16" Socket Wrench
If installing in a mobile home,
insert the lag bolts through
these holes and screw them
into the floor with a 1/2" socket
wrench.
22"
The cover plate is used
to seal off room air.
4111121