Stove Leg Installation; Pedestal (Part # 99200106); Using Outside Air With The Pedestal - Lopi Endeavor Owner's Manual

32

Stove Leg Installation

Part Numbers: Brass # 99200500, Cast Black # 99200800, Sculptured Steel # 99200105

Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
These rubber-tipped bolts are for leveling the stove.
Make sure they contact the floor. Do not adjust
with weight on the legs, the rubber tips may tear.

Pedestal (Part # 99200106)

If using outside air with the pedestal, follow the directions below under "Using Outside Air with the
Pedestal" prior to installing the pedestal.
Attachment Bolts and
Washers - use a 9/16"
socket wrench to
attach the pedestal to
the stove.
OUTSIDE AIR EQUIPMENT (wood stoves only)
Insulation is
used to seal the
side edges of
the pedestal .

Using Outside Air with the Pedestal

Before installing, check the section "Outside Air Requirements" 11 for installation concerns.
1. Determine the location of the outside air hole penetrating the floor (& hearth). The illustration
above details the size of pedestal and its location in relation to the stove. The hole may be cut
anywhere underneath the pedestal, as long as it is not within 2" of the outside perimeter of the
pedestal, is at least 16 square inches in area, and does not interfere with structural members of
the home. Place the rodent screen over the hole (above or below) and secure with staples.
2. Attach the stove to the pedestal with the included bolts. Tuck the included insulation underneath
the side edges of pedestal to seal off any air from entering underneath the pedestal.
© Travis Industries
Optional Equipment
Optional Air Intake Port
23 5/8"
Screen is used
to prevent
rodents from
entering.
100-01275
If installing in a mobile home,
insert the lag bolts through
these holes and screw them
into the floor with a 1/2" socket
wrench.
22"
When attached, the face of the
stove is 2 1/2" in front of the front
edge of the pedestal.
Staples are used to attach
the screen to the floor.
9/16" Socket Wrench
The cover plate
may be discarded.
4111122