Specifications - Makita GA7030 Instruction Manual

SPECIFICATIONS

Model
Depressed center wheel
diameter
Spindle thread
-1
No load speed (min )
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
...................DOUBLE INSULATION
....................Wear safety glasses.
..................Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned
compatible recycling facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
2
GA7030/GA7030F/
GA7030S/GA7030SF
180 mm
M14
8,500
511 mm
5.1 kg
END202-2
with household
equipment and
to an environmentally
GA7040S/GA7040SF
5.5 kg
/II
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavora-
ble mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.23 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
For Model GA7030, GA7030F, GA7030S, GA7030SF,
GA9040S, GA9040SF
For European countries only
Noise and Vibration
waste
The typical A-weighted noise levels are
sound pressure level: 89 dB (A)
sound power level: 102 dB (A)
– Wear ear protection. –
its
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN50144.
For Model GA9030, GA9030F, GA9030S, GA9030SF
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 91 dB (A)
sound power level: 104 dB (A)
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN50144.
GA9030/GA9030F/
GA9030S/GA9030SF
230 mm
M14
6,600
511 mm
5.1 kg
2
.
2
.
GA9040S/GA9040SF
5.5 kg