Table of Contents
Advertisement
Setting input
1
signals
2
Most sources can be
played with "AUTO "
(factory setting).
However, in the
following cases,
change the input signal
3 Press
detection setting.
When the beginning
of the song is cut
during playback of
4 Press
CD, set to "PCM "
(PCM FIX).
When the signal is
not detected during
playback of DTS
sources, set to
"DTS " (DTS FIX).
You can fi x the
signal type (digital or
5
analogue) supplied
by TV.
When noise occurs,
return the setting to
"AUTO ".
1
2
Reset
(factory settings)
The operation settings
for the system will
be initialised to the
3 Press
settings made at the
time of shipment.
•
•
Press and hold
for about 2 seconds.
Press
to select "INPUT
REAL C., BASS, TREBLE, BALANCE, HDMI,
MODE".
TV DELAY, DUAL PRG, DRCOMP, ATTENUATOR,
REMOTE, INPUT MODE, RESET, EXIT
Only appears when audio adjustment can be made.
to select source.
to select input signal.
AUTO : Automatic detection
PCM : PCM (from CDs) digital input fi xed
DTS : DTS digital input fi xed
ANLG (TV only): Fixes the input signal to analogue
DIG (TV only): Fixes the input signal to digital
Repeat steps 3 and 4 to change setting.
Press
a few times to select
"EXIT".
Return to previous menu/cancel.
Press and hold
for about 2 seconds.
Press
to select "RESET".
REAL C., BASS, TREBLE, BALANCE, HDMI,
TV DELAY, DUAL PRG, DRCOMP, ATTENUATOR,
REMOTE, INPUT MODE, RESET, EXIT
Only appears when audio adjustment can be made.
to select "YES".
All the settings are reset when you select "YES" and the input selector automatically switches to
"BD/DVD".
If you select "NO", you will return to step 2. To exit setup mode, press [RETURN] a few times to
display "EXIT", and then press [OK].
TV, DVD, AUX1, AUX2
Factory setting: AUTO
Press
YES, NO
Press
to
confirm.
•
Select "EXIT" and
confi rm to fi nish the
setup mode.
Press
to
confirm.
Press
to
confirm.
Press
to
confirm.
Press
to
confirm.
•
Select "EXIT" and
confi rm to fi nish the
setup mode.
Press
to
confirm.
33
RQTX0151
Hide quick links:
Advertisement
Table of Contents
