Maintenance Schedule; Technical Specifications - Nilfisk-Advance APC 328 Information & Operating Instructions

MAINTENANCE
1) Use only approved chemicals at the recommended mix ratios. All chemicals should be
added through the feed system and NOT added directly to the water in the solution
tank to prevent possible damage to the pump, seals, or other components.
2) For optimum performance, flush the Chemical Feed lines after every job by replacing
the chemical containers with containers of clear water and spraying through the gun
until the fluid stream is clear. See the Maintenance Schedule, below.
3) The pump seals and/or valves in the high pressure pumps may need to be replaced
after about 1000 hours of use, if the pump begins to loose performance or to leak.
The pressure regulator valve may need to be when a drop in the spraying pressure at
the tool is apparent.
ITEM
Flush chemical lines
Check/clean vac inlet filter
Clean solution filter
Check vacuum motor airways
Check pump for leaks
Check vacuum motor brushes *
* Have your distriburor check the carbon brushes once a year or after about 500 hours of operation.

TECHNICAL SPECIFICATIONS

Vacuum motor:
Tank constructions:
Machine weight:

MAINTENANCE SCHEDULE

2-stage, 8 amp
Water lift: 23 kpa
Air flow: 100 CFM
Rotationally molded polyethylene
Height: 98 cm X 59 X 86.5 cm
50 kg
DAILY WEEKLY QUARTELY YEARLY
x
x
x
x
X
x
x