Your Machine - Nilfisk-Advance APC 328 Information & Operating Instructions

YOUR MACHINE

Operator Handle (1): Operator holds onto this handle to move the machine from one location to
another.
Solution Tank Lid (2): This lid screws off so the tank can be filled. The solution fill hose is
tethered to the lid, and hangs inside the arm of the Operator Handle.
Maid's tote and Recovery tank lid (3): This removable container holds often-used items and has a
handle for easy carrying. The recovery tank lid sits under the maid's tote and covers the opening in the
Recovery Tank. This is where the operator can access the tank to clean it and the ball float cage. The
tank can be flushed out by running clean warm water into this opening and laying the open drain hose into
a bucket or drain.
Recovery Hose (4): Waste water is picked-up through this hose.
Spray Hose (5): This hose delivers water from the machine to the cleaning tool.
Drain Hose (6): This hose is used to empty the recovery tank. NOTE: hold the end of the hose above
the water level in the tank to avoid sudden, uncontrolled flow of waste water when you remove the cap,
then lower the hose slowly to control the rate of discharge.
Quick Disconnect (7): Point of attachment for the Spray Hose (5).
Castors and Wheels (8): Castors pivot for ease of steering, and large back wheels make it easy to roll
the machine from location to location.
Chemical Feed Lines (9): These clear tubes connect the cleaning chemical containers to the machine
where the chemical can be siphoned into the outlet water from the pump. Metering tips -- used to change
the ratio of water to chemical -- are installed here.
Switch Plate (10): The machine's on/off switches for the vacuum and for the pump are located here
and this is where the valve to change chemical feeds is located.
Power Cord (11): The 25 ft. power cord connects to a power cord pigtail on the rear of the machine.
Chemical Container Holders (12): Two molded-in bottle holders for chemical jugs.
11
1
2
9
12
6
3
8
4
5
10
7