Table of Contents
Advertisement
SPINTEC 343
SPINTEC 343 H
english
Symbols used to mark
instructions
1 Important safety instructions
These safety instruc-
tions are intended
for users.
bly, start-up and m a i n t e n a n c e
of the cleaner please read the
information and recommenda-
tions in these operating instruc-
tions. This ensures that you are
well acquainted with the cleaner
and can use it efficiently.
Care and maintenance of the
cleaner
in
these
instructions
your safety and retains the value
of the cleaner.
The manufacturer accepts no
liability for personal or mate-
rial damage caused by improper
handling of the cleaner.
Before starting up the cleaner,
read these operating instruc-
tions thoroughly and keep them
in an easily accessible place.
Only allow the cleaner to be
used by persons who have been
trained in its use and who have
been explicitly authorized to use
it.
2
persons are marked with this
danger symbol.
within reach at all times.
Workplace
The workplace is behind the
cleaner.
Before assem-
General
Use of the cleaner is subject to
current national regulations.
Besides the operating instruc-
tions and binding accident pre-
vention regulations valid in the
country of use, observe recog-
accordance
with
nized regulations for safe and
increases
proper work.
Never use unsafe cleaning tech-
niques.
Do not use the cleaner on public
paths and roads.
Electrical connections
CAUTION!
Never push the cleaner over
power cords. Danger of electro-
cution!
Safety
instructions
in
these
operat-
ing
instructions
which must be
observed
to
prevent risks to
Before using the
appliance,
be
sure to also read
the enclosed op-
erating
instruc-
tions and keep them
This indicates
tips and in-
structions
simplify work and
to ensure safe operation.
This symbol is used
to mark safety in-
structions that must
be observed to pre-
vent damage to the
machine and its per-
formance.
Do not damage the power cord
by riding over it, crushing or pull-
ing it, etc.
Check the power cord regularly
to detect signs of damage.
Do not use the cleaner if the
condition of the power cord is
poor.
When using or replacing pow-
er cords, do not use any other
cords than those specified by
the manufacturer.
When replacing couplings or
power cords, ensure that splash
water protection and mechani-
cal strength are adequate.
Do not start the cleaner unless
the power supply in the building
to be cleaned complies with the
specifications on the rating plate
of the cleaner.
Risks
CAUTION!
The cleaner is not suitable to
clean surfaces that release haz-
ardous dust and liquids. Do not
use on steps.
to
Advertisement
Table of Contents
