Nilfisk-ALTO POSEIDON 2-26 PORTABLE Operating Instructions Manual page 2

1 Important safety instructions
Symbols used to mark in-
structions
For your own safety
The high-pressure washer
may only be used by persons
instructed in its use and who
have been expressly authorised
to do so.
Although extremely easy to
operate, children should not be
allowed to use the washer.
General
Use of the high-pressure wa-
sher is subject to the applicable
local regulations.
Besides the operating instruc-
tions and the binding accident
prevention regulations valid in
the country of use, observe re-
cognised regulations for safety
and proper use.
Do not use any unsafe work
techniques.
Transport
Transport of the high-pressure
washer in upright position only.
44
Before using the
high-pressure
washer, be sure
to also read the
enclosed opera-
ting instructions and keep them
within reach at all times.
Safety instructions
in these operating
instructions which
must be observed
to prevent risks to persons are
marked with this danger sym-
bol.
For safe transport in and on
vehicles we recommend to pre-
vent the equipment from sliding
and tilting by fixing it with belts.
For transport at temperatures
around or below 0°C, anti-
freeze should be drawn into the
pump beforehand (see chapter
5).
Before starting the washer
Before use, check that the high-
pressure washer is safe and in
proper condition.
Regularly check whether the
power cord is damaged or
shows signs of ageing.
Use the high-pressure washer
only when the mains power
lead is in a safe condition. (risk
of electric shock if damaged!).
Check the rated voltage of the
high-pressure washer before
connecting it to the mains po-
wer supply. Ensure that the vol-
tage shown on the rating plate
corresponds to the voltage of
This symbol is
used to mark sa-
fety instructions
that must be ob-
served to prevent
damage to the
machine and its performance.
This indicates tips
and instructions to
simplify work and
to ensure safe operation.
the local mains power supply.
We strongly recommend that
the power supply to the high
pressure washer be connected
via a residual current circuit
breaker.
This device stops the supply
of electricity if the leakage cur-
rent to earth exceeds 30 mA for
30 ms or it has an earth tester
circuit.
Operate the washer only in an
upright position!
Please observe the regulations
and provisions applicable in
your country. Before putting the
high-pressure washer into ser-
vice, carry out a visual check of
all the major components.
CAUTION!
High-pressure water jets can
be dangerous if misused. The
jet must not be directed at per-
sons, animals, live electrical
equipment or the washer itself.
Wear appropriate protective
clothing and eye protectors.