Lap Belt - SSANGYONG KORANDO 2005 Owner's Manual

1–30 BEFORE DRIVING YOUR CAR

LAP BELT

A lap belt is installed in the center of the
rear seat.
Insert the metal latch plate into the buckle
until it locks.
To lengthen, hold the metal latch plate at
right angles to the belt and pull on the belt.
To shorten, pull the free end of the belt
away from the metal latch plate, then pull the
belt clip to take up the slack.
Position the lap belt low on the hips.
To remove the belt, depress the red button
on the buckle.
30
K140_RHD_EN_01.p65
The buckle and metal latch plate of the cen-
ter rear lap belt are identified by the "CEN-
TRE" mark. Be sure to check the marking
before wearing the center rear lap belt.
The metal latch plate of the center rear lap
belt can be fastened only into the buckle of
center rear lap belt buckle.
WARNING
Improper use of seat belts could
cause serious injury.
• Never wear the lap belt across your
abdomen.
• Lap belt should be fitted snugly
around the hips, not the waist.
Belt clip
PULL
PULL
PULL to
lengthen
CAUTION
Damaged or incorrectly fastened seat
belt could cause serious injury.
Do not fasten the metal latch into in-
correct buckle by force.
NOTE
When fastening the rear seat shoul-
der belt or the center rear lap belt,
make sure the metal latch plate is
inserted into the correct buckle to
obtain maximum protection from the
seat belt.
INSERT to fasten
PRESS to unfasten
2004-11-11, ¿ÀÈÄ 4:08