SSANGYONG KORANDO 2005 Owner's Manual page 134

6–6 IN CASE OF EMERGENCY
12. Replace and lightly seat the wheel nuts
by turning clockwise.
13. Turn jack connection rod counter-
clockwise and lower vehicle to the
ground.
14. Tighten the wheel nuts firmly to 74
lb-ft (100 ±20 N m); for steel wheel,
•
±7 lb-ft ±10
89 (120 N m); for aluminum
•
wheel according to sequence No. of
below figure.
15. Check and adjust tyre pressure.
16. Secure the jack and tools in their proper
locations.
17. Secure the flat tyre in the spare tyre well
on the tailgate.
6
K140_RHD_EN_06.p65
WARNING
When using the jack the vehicle
could become unstable and move,
damaging the vehicle or badly
injuring.
±14
• Use jack supplied at correct jack-
ing position.
• When installing the jack for lift-
ing the vehicle, it should be per-
pendicular to the ground.
• Do not go under a jacked-up ve-
hicle.
• Do not start engine while jacked up.
• Before jacking, get all passengers
out of the vehicle and clear of ve-
hicle and other traffic.
• Use jack only for changing wheels.
• Do not jack vehicle on an inclined
or slippery surface.
• Use jacking position nearest to re-
quired wheel change.
• Block wheel diagonally opposite
the wheel to be changed.
• Before jacking ensure parking
brake is on and the transmission
is set in 1st or reverse gear
(manual transmission) or P (auto-
matic transmission).
• Do not jack the vehicle and change
the wheel where traffic is close.
STARTING THE ENGINE WITH
JUMPER CABLES
CAUTION
• Do not try to start vehicle by
pushing or pulling it.
• This can damage catalytic con-
verter and automatic transaxle, and
may cause personal injury.
You can start a vehicle that has a dis-
charged battery by transferring electrical
power to it from a battery in another vehicle.
2004-11-11, ¿ÀÈÄ 4:09