Questions And Answers - Siemens Gigaset C380 User Manual

Customer Service & Assistance

Questions and answers

If you have any questions about using your
phone, visit us at www.gigaset.com/service
at any time. The table below contains a list of
common problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥ Press and hold the end call key
2. The batteries are flat.
¥ Charge or replace the batteries
(¢ page 10).
Base
" " flashes in the display.
1. The handset is outside the range of the base
station.
¥ Move the handset closer to the base sta-
tion.
The base station's range is reduced because
Eco Mode mode is activated.
¥ Deactivate Eco Mode (¢ page 41) or
reduce the distance between the hand-
set and base station.
3. The base station is not turned on.
¥ Check the base station's mains adapter
(¢ page 8).
Handset does not ring.
1. The ringer is deactivated.
¥ Activate the ringer (¢ page 46).
You cannot hear a ringer/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥ Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer (¢ page 61).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥ Reset the system PIN to 0000 (¢ page 47).
52
Forgotten the system PIN.
¥ Reset the system PIN to 0000 (¢ page 47).
The other party cannot hear you.
You have pressed the
The handset is "muted".
¥ Activate the microphone again (¢ page 24).
The number of the caller is not displayed
a despite CLIP.
.
Calling Line Identification is not enabled.
¥ The caller should ask the network provider to
release Calling Line Identification (CLI).
You hear an error tone (descending tone
sequence) when inputting.
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for dial pulsing.
¥ Set your PABX to touch tone dialling.
Gigaset C385 only:
No time is specified for a message in the
answer machine history.
Date/time is not set.
¥ Set the date/time (¢ page 13).
The answer machine announces "PIN is incor-
rect" during remote operation.
1 You have entered the wrong system PIN.
¥ Enter the system PIN again.
.
2 The system PIN is still set to 0000.
¥ Change the system PIN (¢ page 47).
.
The answer machine will not record any mes-
sages.
Its memory is full.
¥ Delete old messages.
¥ Play back new messages and delete.
§Mute§
display key.