Siemens Gigaset C380 User Manual page 12

Attaching the belt clip
The handset has notches on each side to accommodate the belt clip.
¤ Press the belt clip onto the back
of the handset so that the
notches on the belt clip click into
position.
Placing the handset in the base station and registering
Place handset
into base
Menu
Handset is
registering ë
Ð
Þ
Menu
If you have purchased a model with multiple handsets, repeat the registration
process for each handset. Handsets are assigned the lowest available internal
number (1-4). If more than one handset is registered to the base station the internal
handset number appears on the display, e.g. INT 2. If the internal numbers 1–4 are
already assigned to other devices, the number 4 will be overwritten.
Before you can use the phone, you must first
register the handset to the base station.
¤ Place the handset with the display facing
up in the base station.
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
V
The following is displayed after successful reg-
istration:
u the strength of the reception signal
between base station and handset:
– good to poor: Ð i Ñ Ò
– no reception: | flashes
u battery charge status:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging proce-
dure
First steps
11