Table of Contents
Advertisement
Problem
Buttons do not work.
Door does not open.
Unusual odour
No water going into
the appliance.
There is only a small
amount of water.
Water builds up
during the washing.
No water flows into
the appliance during
the rinsing process.
Rinsing begins
before the spin
process finishes.
During spin-dry,
the drum stops and
rotates several times.
Foam and water
remain in the door or
door seal.
Spin cycle repeatedly
starts and stops.
The laundry is still
wet after the spinning
finishes.
NA-148VB4_English.indb
27
-
The programme, temperature, preset time, or Extra Rinse
function settings cannot be changed while washing is in
progress.
-
Child lock may be activated. (See page 22.)
-
Door lock may be activated. (See page 13.)
-
The water temperature or level may be too high. (See
page 13.)
-
Rubber parts may give off a smell when you start using
the appliance, but the smell will go away over time.
You can wash the drum by running the 90°C programme.
(See page 24.)
-
The water tap might be turned off.
-
The water-supply hose may be frozen. (See page 26.)
-
The water supply may be disrupted.
-
The water-supply filter may be clogged. (See page 26.)
-
If you have paused the washing and then restart it, the
appliance may drain out some water.
Do NOT pour water in through the door.
-
This is normal; water is automatically supplied if the
amount of water has decreased. For heavy loads, the
water may fill up repeatedly.
-
Before rinsing, the appliance spins to drain out remaining
water. The water will fill up after that.
-
After washing, excess foam may remain, so the water is
drained out and refilled to wash it away. This feature is
called foam detection.
-
This is normal; the appliance has detected an unbalanced
load and is trying to correct it.
-
Although some foam and water might remain depending
upon the state of the laundry and the amount of detergent
used, the performance of the rinse cycle is unaffected.
-
This is normal; intermittent spinning of the tub helps the
spin process to operate quietly.
-
The laundry may be too light. If so, add one or two bath
towels.
-
An unbalanced load is not corrected automatically.
-
If the laundry is too light, add one or two bath towels.
-
If the laundry gets tangled up, untangle it.
Fault Checklist
Cause
Troubleshooting - 27
2011-12-26
13:58:20
Hide quick links:
Advertisement
Table of Contents
