Troubleshooting - Panasonic NA-F150A5 Operating & Installation Instructions Manual

Troubleshooting

Symptoms
Time indication increases
or does not decrease
Operation time is longer
than the time indication.
Operation does not stop
even after the preset time.
No operation
Cannot change process
settings (after start-up).
No water supply
Water is supplied in the
middle of wash process.
The water level is too high
for the amount of laundry.
The water level is too low
for the amount of laundry.
Operation started with
rinse, but water is not
supplied.
Operation suddenly
changes to rinse process in
the middle of spin.
Only spin is desired, but
operation starts with rinse.
Irregular rotation during
spin
Points to be checked
- Time indication is approximate. Remaining time is
corrected during operation and displayed.
- The operation time may be longer if laundry is
concentrated on one side or the water supply or
drainage is not good.
(P. 28 "U 11" "U 14")
- Power failure?
- Is the lid closed completely?
- Has the power fuse blown or the breaker tripped?
- Is the power plug inserted completely?
- Is the water faucet turned on?
- Did you press "Start"?
- Is the timer preset?
- Process settings can be changed during wash
process by pressing "Pause". To change the
program or settings after the end of wash process,
turn the power off and on again.
- Is the water faucet turned on?
- Water outage?
- Is the water supply filter clogged with dirt?
- If the water level drops, water is added automatically.
- With a large amount of laundry, water is added
several times automatically.
- If laundry is wet or there is water in the tub before
operation, the water level may be higher.
- With light clothes (of synthetic fibre, etc.), the water
level may be lower.
- If there is no water in the tub, water is supplied after
spin.
- If there is water in the tub, water is supplied after
water discharge.
- If clothes are concentrated on one side of the
tub, the washing machine automatically corrects
unevenness by starting rinse process.
(Place clothes as evenly as possible.)
- The tub rotation speed is adjusted to reduce foaming
during spin.
(P. 23)
29