Error Display - Panasonic NA-127VB4 Operating Instructions & Installation Instructions

Error Display

Error
Door is open
Unable to supply
water
Unable to drain
Overflow
Supply water is
cut-off or water
pressure is low.
Drain filter is
clogged.
To restart the operation after an error message appears, set the programme selection dial to
Off, and then select a programme and start the operation.
30 - Troubleshooting
NA-148VB4_English.indb 30
Make sure that the door is shut properly.
Check for any of following problems.
- The tap is closed.
- The water pipe or hose is frozen.
- The water supply has been disrupted.
- The water-supply filter is clogged. (See page 26.)
If the red mark appears in the hose with water-supply valve, it
have been stop the water supply.
You should replace with a new hose.
Hose with water-supply valve
Check the drain hose for any of following problems.
- It clogs up.
- Its tip is immersed in water.
- It extends with joints.
- The water is frozen.
Clean the drain filter if it clogs up. (See page 23.)
Check for any of following problems.
- The water-supply valve has failed.
- The water-supply valve triac has failed.
Switch off and unplug the appliance. Shut off the tap and contact
your local Customer Service Centre.
If the light flashes, check for any of following problems.
- The tap is closed.
- The supply water is cut-off.
- The supply water pressure is low.
- The water-supply hose is clogged or twisted.
- The water-supply filter is clogged. (See page 26.)
If the light flashes, check for any of following problems.
- The drain filter is clogged. (See page 23.)
- The water-drain hose is clogged or twisted.
What to do
2011-12-26 13:58:21