Specifications; Initial Tool Set Up/ Assembly - Central Pneumatic 68128 Set Up And Operating Instructions Manual

3. Wear suitable gloves to reduce the
vibration effects on the user.
4. Use tools with the lowest vibration
when there is a choice.
5. Include vibration-free periods each
day of work.
6. Grip tool with both hands as lightly as
possible (while still keeping safe con-
trol of it). Let the tool do the work.
7. To reduce vibration, maintain tool as
explained in this manual. If abnormal
vibration occurs, stop immediately.
SAVE THESE
INSTRuCTIONS.
SKU 68128 For technical questions, please call 1-800-444-3353.

SPECIFICATIONS

Maximum Air Pressure
Air Inlet
Drive Size
Maximum Speed*
Average Air
Consumption
Recommended Min.
Air Hose
Torque
Speed Settings
* Maximum speed at stated maximum air pressure. Ex-
cess air pressure is hazardous and may cause the tool
to exceed stated maximum speed.
Recommended Min. Air Hose: 1/2" (Not Supplied)
INITIAL TOOL SET uP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
unpacking
When unpacking, make sure the item
is intact and undamaged. If any parts
are missing or broken, call Harbor Freight
Tools at 1-800-444-3353.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
90 PSI
1/2" -14 NPT
1"
3200 RPM / 557 BPM
(Blows Per Minute)
10 CFM @ 90 PSI
1/2" (Not Supplied)
2000 ft.-lb.
Three
Page 6