Table of Contents
Advertisement
1.) Press the STANDBY/ON button on the top panel or
button on the remote control to turn the system 'On'. The
initial default mode for this system is the iPod function.
The "iPod" indicator will flash above the time display.
2.) Touch the MODE button on the top panel or press the
MODE on the remote control until a FM or AM frequency
appears above the time display.
3.) Tune to the desired station as follows:
• Automatic Tuning
Press and hold the
TUNE/ SKIP
change, then release the buttons. The tuner will search down or up the band for the
next strong signal and stop on that station.
• Manual Tuning
Repeatedly press the
SKIP
/
desired station. Note: Use the Manual Tuning method to tune to stations with weaker
signals that may be bypassed during Automatic Tuning.
4.) If you tuned to a FM stereo station the stereo (ST)
indicator will appear in the display. If FM stereo
reception is noisy or weak, press the FM ST button
on the remote control to select the FM Mono mode.
This will usually improve the reception but the sound
will no longer be in stereo.
5.) When you finished listening press the STANDBY/ON button on the top panel or
/ON button on the remote control to turn the system 'Off'. The radio station
frequency disappears from the display.
RADIO OPERATION
/
/
buttons on the top panel until the frequency display starts to
/
buttons on the top panel until the display shows the frequency of the
buttons on the remote control or touch and hold the
buttons on the remote control or touch the TUNE/
14
/ON
Advertisement
Table of Contents
