Table of Contents
Advertisement
Make sure that you have fully extended the FM antenna wire.
l
Be sure to connect the external AM loop antenna to the AM ANT Jack on the back
l
panel if you are planning to listen to AM radio stations (refer to page 15 for
connection information) .
Make sure you have removed the mylar insulation tab from the remote control.
l
Make sure that the system is connected to an AC outlet that is always "live".
l
Do not connect the system to an AC outlet controlled by a wall switch.
l
General Controls
Most of the main functions of this system can be operated by the controls on the top panel of the
main unit, or by the buttons on the remote control. If a specific function can only be operated by
the remote control, or by the top panel controls, this will be clearly indicated in the instructions.
When operating this system with the remote control, make sure that the IR (Infrared) transmitter
on the front of the remote control is pointed at the remote sensor on the front panel of the main
unit.
The effective operating range of the remote control is approximately 20 feet. Please note that
bright sunlight or room lighting may interfere with the remote control operation. If the remote
control is not operating properly, try reducing the brightness of the room or moving closer to the
main unit. If this does not solve the problem, it may be time to change the remote control battery.
Auxiliary Input Jack
This system includes an AUX IN Jack to allow you to connect external audio equipment
and listen to the sound from the external equipment through the speakers of this system.
To listen to the external audio source:
• Connect the external audio equipment to AUX IN jack on the rear panel of the system
as shown below. The connection cable is not included.
Select the AUX mode by repeatedly pressing the MODE button
on the top panel or by repeatedly pressing the MODE
button on the remote control until the "AUX" indicator appears
above the time display.
OPERATING INSTRUCTIONS
CONNECTING EXTERNAL DEVICES
FM ANT
AUX IN
DC IN 10V
AM ANT
Signal cord(not included)
plug
10
External audio source
Advertisement
Table of Contents
