Sanyo PLC-SW35 Owner's Manual page 51

Multimedia projector
Table of Contents

Advertisement

Some displays are not seen
during the Operation.
PIN code dialog box appears at start-up. – PIN code lock is being set. Input a PIN code (1234 or numbers you have
The Remote Control does not work.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the
service center. Give the model number and explain about the problem. We will advise you how to obtain service.
The CE Mark is a Directive conformity
mark of the European Community (EC).
Pixelworks ICs used.
– Check the Display item. (See "Setting" on page 38.)
set). (See "PIN code lock" on page 17 and 43.)
– Check the batteries.
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote
control. Maximum operating range is 16.4' (5m).
– Make sure the code of the remote control is conformed to the projector.
(See page 42.)
– Unlock Key lock for the remote control in the Setting Menu. (See page 42.)
This symbol on the nameplate means the product is
Listed by Underwriters Laboratories Inc. It is designed
and manufactured to meet rigid U.L. safety standards
against risk of fire, casualty and electrical hazards.
Appendix
51

Advertisement

Table of Contents
loading

Table of Contents