Table of Contents
Advertisement
Setting
Remote control
This projector has two different remote control codes; the factory-
set normal code (Code 1) and the secondary code (Code 2). This
switching function prevents remote control interference when
operating several projectors or video equipment at the same time.
When operating the projector in "Code 2", both the projector and
remote control must be switched to "Code 2".
To change the code of the projector :
Set the remote control in the Setting menu to "Code 2."
To change the code of the remote control :
Press and hold both MENU and IMAGE buttons on the remote
control together for 10 seconds or more. After changing the code,
make sure the remote control operates properly.
To return to the normal code (Code 1), operate both the projector
and remote control in the ways above again.
✔
Note :
When battery of the remote control is replaced, the remote control
code automatically returns to the normal code (Code 1).
Key lock
This function locks operation of the top control and remote control.
It is useful to prevent operation by an unauthorized person.
···· not locked.
···· locks operation of the top control. To unlock, use the
remote control.
···· locks operation of the remote control. To unlock, use
the top control.
If the top control accidentally becomes locked and you do not have
the remote control nearby, disconnect the AC power cord from
the AC outlet, and then with pressing the SELECT button, reinsert
the AC power cord. This will cancel the top control lock.
42
ON - OFF
COMPUTER VIDEO
Remote control
VOLUME -
VOLUME +
MENU
SELECT
D.ZOOM
KEYSTONE
IMAGE
NO SHOW
P - TIMER
FREEZE
AUTO PC
MUTE
Key lock
Press and hold
MENU and IMAGE
buttons for 10 seconds
or more.
SHOW
Select Key lock and
this box appears.
Choose
one
of
these
with
the
Point e e d d button
and select [Yes] to
activate it.
Advertisement
Table of Contents
