Table of Contents
Advertisement
■ Procedure
1
Set the exposure mode other than the
Programmed AE.
2
Attach the flash unit to the camera's hot shoe
and turn it on.
3
Set the sync mode switch to high-speed sync
[
].
HS
• The flash will be set to High-speed-sync mode
and [
] will be shown on the LCD panel only
HS
when the shutter speed exceeds X-sync speed.
4
To set exposure compensation, press the [S]
button so that [0.0] blinks. Then turn the
adjustment
dial
compensation amount. Press the [S] button
again to stop the blinking.
The exposure compensation amount can be
set from +1.0 to -3.0 stops in 0.5-stop
increments.(p.39)
《30》
to
set
the
exposure
5
In the Auto zoom mode, the zoom position and
camera focal length match automatically.
In the Manual zoom mode, set the zoom
position manually.
6
Check the flash range by looking at the bar
graph on the LCD panel.
7
Check that the flash is ready and then take the
picture.
• High-speed sync mode can be used in the
wireless mode (SLAVE 1).
Hide quick links:
Advertisement
Table of Contents
