Connecting The Base Unit; To A Pabx; Dialling Mode And Recall (Flash); Setting Pauses - Siemens Gigaset C340 Operating Instructions Manual

Handset at a glance
Hide thumbs Also See for Gigaset C340:
Table of Contents

Advertisement

Gigaset C340 / CHIN eng / A31008-M1621-Y101-1-7619 / pabx.fm / 14.9.05

Connecting the base unit

to a PABX

The following settings are only necessary
when your PABX requires them; please
refer to the operating instructions for your
PABX.
You cannot send or receive text messages
on PABX's that do not support Caller ID.

Dialling mode and recall (flash)

The current setting is indicated by ‰.
Changing the dialling mode:
The following dialling modes can be
selected:
u

Tone dialling (DTMF),

u
Pulse dialling (DP).
¢
¢
Settings
§Menu§
¢
Features
Dialling Mode
s
Select a dialling mode
(‰ = on) and press
a
Long press (idle status).
Setting the recall (flash)
¢
¢
Settings
§Menu§
¢
Features
Recall
q
Select recall time (‰ = on)
and press
a
Long press (idle status).
Select 80ms, 120ms,etc.

Setting pauses

Changing pause after line seizure
You can set the length of the pause that is
inserted between pressing the talk key c
and sending the phone number.
5 4 O 1 L
§Menu§
¢
Base
Additional
.
§OK§
¢
Base
Additional
.
§OK§
Connecting the base unit to a PABX
~
Enter a number for the pause
length (1 = 1 sec.; 2 = 3 sec.;
3 = 7 sec.) and press
Changing pause after recall
You can change the length of the pause if
your PABX requires this (refer to the oper-
ating instructions for your PABX).
5 4 O 1 2
§Menu§
~
Enter a number for the pause
length (1 = 800 ms;
2 = 1600 ms; 3 = 3200 ms)
and press
§OK§
Changing the dial pause (the pause
after the area code)
Requirement: You have stored an area
code.
5 4 O 1 1
§Menu§
~
Enter a number for the pause
length (1 = 1 sec.; 2 = 2 sec.;
3 = 3 sec.; 4 = 6 sec.) and
press
.
§OK§

Switching temporarily to

tone dialling (DTMF)
If your PABX still operates with dial pulsing
(DP) but tone dialling is needed for a cer-
tain connection (e.g. to check the network
mailbox), you must switch to tone dialling
for the call.
Requirement: You are conducting a call
or have already dialled an outside number.
Press the control key.
§Menu§
Select
Tone
Tone dialling only active for
this call.
.
§OK§
.
and press
.
§OK§
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gigaset m56

Table of Contents