Table of Contents
Advertisement
Gigaset C340 / CHIN eng / A31008-M1621-Y101-1-7619 / starting.fm / 14.9.05
Preparing to use the phone
u
If you buy a replacement phone cord in
the shops make sure that the phone
jack has the correct type of wiring.
Correct phone jack wiring
3
2
1
Setting up the handset for use
Inserting the batteries
Caution:
Use only the rechargeable batteries recom-
mended by Siemens on page 27! Under no cir-
cumstances should you use a conventional
(non rechargeable) battery or other battery
types as this could cause significant damage to
health and property, e.g. the outer casing of
the batteries could be destroyed or the batter-
ies could explode. The phone could also mal-
function or be damaged as a result of using
batteries that are not of the recommended
type.
¤
Fit the batteries with the correct
polarity.
¤
Position the battery cover against the
edge 1 and push down until it clicks
home.
6
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused
1
Opening the battery cover
¤
Push the catch 2 away from the loud-
speaker 1 and lift the cover up.
1
Placing the handset in the base and
registering it
¤
Place the handset in the charging cra-
dle of the base unit with its display fac-
ing forward.
The handset registers automatically. Reg-
istration takes around 1 minute. While this
is happening,
Registering
display and the name of the base,
flashes. The handset is given the lowest
available internal number (1–4). When
the handset has registered, this number
appears in the display, e.g.
means that the handset has been allo-
cated the first internal number. If all inter-
nal numbers 1–4 have been assigned
(four handsets are registered on a base),
the number 4 is overwritten if that hand-
set is in idle status.
Notes:
– Automatic registration is not possible when
the base on which you wish to register the
handset is being used to make a call.
– A key press cancels automatic registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 17).
– The name of the handset can be changed
(page 19).
2
appears in the
Base
1,
1. This
INT
Advertisement
Table of Contents
