Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset C340 Operating Instructions Manual

Handset at a glance
Hide thumbs Also See for Gigaset C340:
Table of Contents

Advertisement

Gigaset C340 / CHIN eng / A31008-M1621-Y101-1-7619 / appendix.fm / 14.9.05

Appendix

Appendix

Care

¤
Wipe the base and the handset with a
damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth as this can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.

Questions and answers

If you have any queries about the use of
your phone, you can contact us at
www.siemens.com.cn/shc
Or call to the hotline: +86-4006 706 007
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press the 'end call' key
2. The battery is flat.
¥
Charge the battery or replace it
(page 6).
The handset does not respond to a key
press.
26
The keypad lock is activated.
¥
1. The handset is outside the range of the
2. The handset has been de-registered.
3. The base is not switched on.
!
" Please Register" flashes in the display.
No base is switched on or within range.
¥
¥
Handset does not ring.
1. The ringer is switched off.
2. Call diversion is set to
You hear no ring tone/dial tone.
The base's telephone line cord has been
replaced.
¥
The other party cannot hear you.
You have pressed the
set is "muted".
¥
a
and hold.
#
Press the hash key
"Base x" flashes in the display.
base.
¥
Move the handset closer to the base.
¥
Register the handset (page 17).
¥
Check the base's mains adapter
(page 5).
Move the handset closer to the base.
Check the base's mains adapter (page 5).
¥
Activate the ringer (page 22).
¥
Switch off call diversion.
When buying a replacement line cord,
ensure that the line plug has the correct
type of wiring (page 6).
u
Cancel muting (page 11).
long (page 7).
All
Calls.
(§INT§) key. The hand-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gigaset m56

Table of Contents