Sharp UX-BD80 Operation Manual page 51

4
Enter a name for the auto-dial number. To enter each letter, hold down
the key for the letter as shown in the chart below until the letter appears
in the display. Up to 8 characters can be entered.
SPACE, PAUSE (
A, B, C =
D, E, F =
G, H, I =
J, K, L =
To clear a mistake, press
5
Press .
6
Enter the number by pressing the number keys. Up to 24 digits can be
entered. (Note: A space cannot be entered.)
•
To clear a mistake, press
•
If a pause is needed between any of the digits to access an outside line or
a special service, hold down
be entered in a row.
•
If you are on a PBX that requires dialing a number to dial out and are
storing a number for an outside line, enter the number, hold down
until " " appears to insert a pause, and then enter the phone number.
(When you dial the auto-dial number, you will automatically dial out without
the need to dial the number for an outside line.) Note that if you are on a
Flash-type PBX, you must press the
an auto-dial number (the
number).
7
Press .
Storing and Using Auto-Dial Numbers
), - = M, N, O =
P, Q, R, S =
T, U, V =
W, X, Y, Z =
=
. To clear all entered letters, hold down
. To clear all entered digits, hold down
until "
key cannot be stored in an auto-dial
# ( ), ?, _ =
NUMBER?
" appears. Several pauses can
key each time you dial out using
DONE
.
.
49