Line Error - Sharp UX-108 Operation Manual

Line error

Problem
LINE ERROR appears in
the display and/or a
transaction report is printed
out with COM. E-1, 2, 3, 4,
5, 6, or 7 in the NOTE
column.
Dialing and transmission problems
Problem
No dial tone when you pick
up the handset or press the
SPEAKER key.
Dialing is not possible.
Check and remedy
• • • •
Try the transaction again. If the error persists,
check the following:
• • • •
Check the hookup. The cord from the TEL. LINE
jack to the wall jack should be no longer than six
feet.
• • • •
Make sure there are no modem devices sharing
the same telephone line.
• • • •
Check with the other party to make sure their fax
machine is functioning properly.
• • • •
Have your telephone line checked for line noise.
• • • •
Try connecting your fax to a different telephone
line.
• • • •
If the problem still occurs, your fax machine may
need service.
Check and remedy
• • • •
Make sure the handset cord is connected to the
correct jack. See "Handset" in "Connections" in
Chapter 1.
• • • •
Make sure the power cord is properly plugged
into a power outlet.
• • • •
Make sure that the telephone line is properly
connected to both the TEL. LINE jack and the
wall jack.
• • • •
Make sure that the fax is set to the correct
dialing mode for your telephone line. See Option
Setting 8 in Chapter 8.
Problems and Solutions
75