Table of Contents
Advertisement
Selection of X1/Z1 and X2/Z2 reports
to be printed in the stacked report sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request, up to maximum of 13 reports*. This function continuously prints a
maximum of 13 kinds of reports with a single operation.
Procedure
.
2620
* 1
≈
Job no.
*: Maximum 70 steps are programmable. "1 step" means the memory size used for one no-range type job no.
The range type job no. needs "8 steps".
Job code numbers to be used are as follows.
*1
Job no.
Report
General report
00
Full department report
10
Full department group report
13
PLU report
20
PLU zero sales report
27
PLU price category report
29
Transaction report
30
Total in drawer report
31
Commission sales report
32
Full clerk report
40
Full cashier report
50
Hourly sales information
60
70
Daily net report
*3: Both range setting and full setting are allowed.
Note
When Z of stacked report is initiated, X only reports will be skipped.
Example
≈
To cancel the stacked report sequence
For full reporting (non-range report)
* 2
Start range
parameter
To repeat*
Available mode
X1/X2 mode only
X1/X2 mode only
X1/X2 mode only
X1/X2 mode only
X1/X2 mode only
X1/X2 mode only
Range report is available
only in the X1 mode.
X1/X2 mode only
Key operation
. ≈
2620
10
13
PGM 2
*2
≈
End range
parameter
For individual reporting
*2
*3 Start PLU code/end PLU code (1 through 999999)
*3 Start price amount/end price amount
*3 Start time/end time (0 through 2330)
:
:
;
2620
:
;
Range parameter
Print
61
Advertisement
Table of Contents
