Table of Contents
Advertisement
• Numerals, letters and symbols are programmable simply by pressing the corresponding keys.
• Characters may only be entered in single size or in double size. By default, the single-size character mode
is selected. To enter a character in double size, press the
character.
Example
To program the word "SHARP" in double size, do the following key-in.
Î S Î H Î A Î R Î P
• Letters of alphabets "A" through "Z", "Ø" and "Æ"are possible to be entered in lower case or in upper case. By
default, the upper-case letter mode is selected. To enter a character in lower case, press the
before you enter the character. To return to the upper-case letter mode, press the
Example
To program the word "Sharp", do the following key-in.
S Ó H A R P
• Symbols and special letters are programmable by using the
key before you enter the corresponding character.
Example
To program letters "# Ä Å" with the letter "#" being double size
Î é = é ê A é ë A
Editing the characters
You can edit the characters you entered. Pressing a character key replaces the current character with a new
one. To edit the characters, use the
: Backs up the cursor, erasing the character to the left.
Entering character codes
• Numerals, letters and symbols are programmable by entering character codes and the
alphanumeric character code table on the next page. In this way, you can program characters other than the
characters on the programming key sheet.
XXX
• Double-size characters can be made by entering the character code 253.
Example
To program the word "SHARP" with the letter "S" being double size
253
key.
º
XXX: Character code (3 digits)
º
º
º
083
072
S
H
Î
key before you enter the corresponding
é
key. To enter a character, press the
º
º
065
082
080
A
R
Ó
key
Ó
key again.
é
º
key. See the
º
P
13
Advertisement
Table of Contents
