Table of Contents
Advertisement
USER SETTINGS
SELECTING A SETTING FOR A SYSTEM SETTING
1
Hold down the [Light] key (
the alarm indicators ( ,
) blink.
2
Enter the program number with the
numeric keys.
If you enter the wrong number, press the
Note
[CLEAR] key (
number.
3
Press the [START] key (
Audible signals (key entry beep, invalid key beep, base setting beep)
The machine sounds three different types of beep signals: a key entry beep that sounds when a valid key is
pressed, an invalid key beep that sounds when an invalid key is pressed, and a base setting beep that sounds
when a setting is the same as the base setting (base settings are explained below). The base setting beep is
initially disabled. If you wish to enable the base setting beep, see "Base setting beep signal" on page 37. If you
wish to change the volume of the beep signals or disable them, see "Audible signals volume" on page 37.
The beep patterns of each type of beep signal are as follows:
Key entry beep ......................... One beep
Invalid key beep ......................Two beeps
Base settings
The base settings are preset standard selections for each copy setting. The base settings are as follows:
Copy ratio ........................................ 100%
Light and Dark indicator........................ 3
Paper feed location ....... Upper paper tray
38
) until
,
,
,
The display shows "- -"
with the left hyphen
blinking.
• See
"SYSTEM
SETTINGS" (p.36
to
p.37) for the program
numbers.
• The selected program
number blinks.
• For example, to select
"Auto clear timer",
press the [1] key.
) and then enter the correct
).
• The selected program
number stops blinking
and lights steadily.
• The currently selected
setting code blinks on
the right side of the
display.
4
Enter the desired setting code by
pressing a numeric key.
If you enter the wrong number, press the
Note
[CLEAR] key (
5
Press the [START] key (
To select a setting for another system setting,
Note
press the [CLEAR] key (
to step 2.
6
Press the [Light] key (
the settings.
The alarm indicators ( ,
off and the display returns to the number of
copies display.
Base setting beep ................ Three beeps
ORIGINAL SIZE........................................A4
AUTO/TEXT/PHOTO (
AUTO
............................................................ AUTO
• For the setting codes,
see
"SYSTEM
SETTINGS".
(p.36
to
p.37)
• The selected setting
code blinks.
• For example, to select
90 seconds, press the
[5] key.
) and return to step 2.
).
The selected setting
code stops blinking and
lights steadily.
) and then return
) to complete
,
,
,
) go
/
/
)
Advertisement
Chapters
Table of Contents
