Loading Copy Paper - Sharp AR-5015 N Operation Manual

LOADING COPY PAPER

To save space, this copier has been designed with one (AR-5015 N) or two
(AR-5120) adjustable front-loading trays, which are easily opened for paper
loading. For best results, use only SHARP recommended paper. (See page 50.)
The paper required ( ) indicator will light up when there is no copy paper in
the selected paper feed station, or when the paper tray is not installed or is
improperly installed.
When the paper size is changed in the paper tray, the size of
the paper must be entered by steps 8 through 11 on page
12. If not, the edges of copies may become smudged with
toner. Also, the AUTO PAPER SELECT (AR-5120 only) and
the AUTO IMAGE feature will not function properly.
Maximum height line
10
Gently lift and pull out the paper tray until it stops.
1
Push the pressure plate down until it locks in place.
2
Fan the copy paper and insert it into the tray. Make sure
3
the edges go under the corner hooks.
G
If you change to a different size of copy paper, the tray must be
adjusted. See the next page.
G
Set the paper along the guides.
G The tray holds up to 250 sheets of paper.
Do not load paper above the maximum height line.
Push the paper tray firmly back into the copier.
4