Delta MD 11871 Manual page 36

1. Make the marks of buttonhole carefully on the
material.
2. Pull forward slide (A), keep the mark (C) on it in
conformity to the initial mark (B),The mark on
the presser foot should be aligned with that of
the material. Lower the sewing foot.
Instruction:
marks on the slide should be carved in cm.
3. Adjust stitch selection dial to
forward until comes to the marks in front of the
buttons and then stop sewing with needle
pausing at top left.
4. Adjust stitch selection dial to
stitches before stopping sewing with needle
pausing at top right.
5. Adjust stitch selection dial to
backward until come to the marks at the back of
buitons and then stop sewing with needle
pausing at top right.
6. Adjust stitch selection dial to
stitches before stopping sewing with needle
pausing at top left.
7. After sewing: buttonholes, take out fabrics.
Insert a pin at the back hole of buttonhole so that the end of thread of
buttonhole will not be cutting off. Cut out the buttonhole carefully with a
buttonhole cutter.
Note: Pin a safety pin in front of the top bar to stop you cutting through it.
Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: MD 11871
. Keep stitching
. Make 4-6
. Keep stitching
. Make 4-6
38