Delta MD 11871 Manual page 28

Using the strips of leg wire on the needle plate
The Strips of leg wire on the needle plate is of
great help to maintaining width between the
needle and the thread.
Instruction: these data conform to the distance
between strips of leg wire and the needle.
Caption of figure
(1) Strips of leg wire
(2) Comer
(3) Needle plate
(4) Hole of needle plate
(5) The width of sewing to the center of needle
Figure on the needle
plate
Spacing in cm
Sewing a right angle
While doing right stitches, a space of 1.6
cm should be kept apart from the edge of
fabric
1. When the edge of fabric is aligned
with the corner, stop the machine
2. Turn the hand wheel towards you
until the needle is dropping into the
fabric.
3. Raise the presser foot, turn the fabric
around the needle to change direction until its edge is aligned with the strip
of leg wire of 5/8 (1.6 cm).
4. Lower the presser foot and sew in the new direction.
Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: MD 11871
10 15 20
1.0 1.5 2.0
3/8 4/8 5/8
1.0 1.3 1.6
6/8
1.9
30