Sharp AR-280 Operation Manual page 41

READY TO COPY.
CANCEL
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
OK
CANCEL
OK
(0~1)
1
inch
INTERRUPT CLEAR ALL
CA
START
CLEAR
C
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
AUTO AUTO A4
EXPOSURE PAPER SELECT
4
Select the desired erase mode.
Select "EDGE ERASE", "CENTRE ERASE" or "EDGE+CENTRE
OK
ERASE" on the touch panel. The selected erase mode will be
OK
highlighted.
(0~1)
1
inch
Adjust the amount of edge erase and/or centre erase if
5
OK
needed.
OK
The amount can be adjusted between 0 mm and 20 mm in 1 mm
increments (0" and 1" in 1/8" increments).
(0~20)
10
mm
6 Press the upper "OK" key on the touch panel.
7
Make all other desired copier selections and press the
START (
If the document feeder is used, scanning of originals and
copying will start.
If the document glass is used in the SORT mode, proceed to the
next step.
8 Replace the finished original with the next original after
the START (
the START (
have been scanned. Then, press the "READ-END" key
READ-END
on the touch panel.
Copying will start at this time.
100%
COPY RATIO
Up to 120 sheets of A4 (8-1/2" x 11") originals or up to 60 sheets
of originals larger than A4 (8-1/2" x 11") can be scanned.
To cancel the ERASE function, select the ERASE function again
and press the "CANCEL" key.
) key.
) key indicator lights up, and then press
) key. Repeat this step until all originals
ERASE
3-7